it doesnt matter what type of display I am using .. important is that I need functional overscan correction, without degrading srceen parametrs, like ATI Radeon have!
I tryed connect new TV, which have "Just Scan" (1:1 maping) function, but there is another problem!!!
I have satellite receiver, blue-ray player and NUC htpc connected through YAMAHA receiver (with HDMI 1.4a) with Samsung TV.
So If I switch HDMI input on receiver, for example to blueray player, TV redetect HDMI input and set "16:9" mode (with overscan) again. Then I switch to NUC and I need set again "Just scan" mode. ITS SOOOO ENOING !!!!! grrrr
On old HTPC with ATI Radeon, I have to just set overscan correction and everythink was OK, screen was sharp like needle!
I have one idea yet! I will try remove 19 pin (hot-plug) in HDMI cable which connected receiver and TV.
I hope it cause that TV doesnt notice that HDMI input device was changed so there isnt any redetection and "Just Scan" doesnt switch back to "16:9" mode